Author name: dcote

The two terms overlap and are often used interchangeably, although neither is clearly defined by standards or practices. Here, we will look at the methods used to calculate these parameters on your Adcole meter.

This article will explore the reasons for chatter in shaft components, evaluation methods, and output of measurements to improve shaft quality in high-demand assemblies.

Adcole understands how important linear profile measurements are for advanced manufacturers producing precision components and offers a utility that enables engineers to obtain linear measurements in an easily understood format.

It’s not uncommon for manufacturers to puzzle over why their crankshaft journals are showing material build-up on the leading or trailing edges of a component. As this is a very specific manufacturing issue, obtaining good data about the problem can be an exercise in frustration.

This software solution enables engineers to detect chatter that occurs in only a small angular window of the journal or lobe surface (burst chatter), without diluting the amplitude by analyzing over a larger angular window or over the entire 360⁰.

To help automotive and machine manufacturers quickly identify defects, tolerance deviations, and nonconformities that may not be readily apparent in traditional geometric defect reports and charts, Adcole has developed 3D Color Map software.

Did you know that our Program Builder software offers powerful features that help drive productivity and improve your quality process?

When it comes to cylindrical parts, you can choose between a machine that takes radial measurements using a single-point probe (usually a roundness gage) or one that uses contact points for diameter measurement (a diameter gage).

In ongoing efforts to improve efficiency and reduce the CO2 footprint of their fossil fuel engines, engine manufacturers are shaving microns off the tolerances of rotating components such as camshafts and crankshafts.

This post helps clarify some frequently asked questions you may have about parallelism. First, we define parallelism, then we discuss the coordinate system.