Author name: dcote

The two terms overlap and are often used interchangeably, although neither is clearly defined by standards or practices. Here, we will look at the methods used to calculate these parameters on your Adcole meter.

This article will explore the reasons for chatter in shaft components, evaluation methods, and output of measurements to improve shaft quality in high-demand assemblies.

To help automotive and machine manufacturers quickly identify defects, tolerance deviations, and nonconformities that may not be readily apparent in traditional geometric defect reports and charts, Adcole has developed 3D Color Map software.

When it comes to cylindrical parts, you can choose between a machine that takes radial measurements using a single-point probe (usually a roundness gage) or one that uses contact points for diameter measurement (a diameter gage).

In ongoing efforts to improve efficiency and reduce the CO2 footprint of their fossil fuel engines, engine manufacturers are shaving microns off the tolerances of rotating components such as camshafts and crankshafts.